Costway NP10884 Instructions De Montage page 13

Jiaxing Hero Precision Machinery Co., LtdW3368#Zhongshan Road,
XiuzhouZone, Jiaxing. Zhejiang, China. Item Number:NP10883 NP10884
Model No.:P014-776
Type of gas: Propane Normal Hourly input 30,000BTU/hr(11.72kw). For
Outdoor Use Only. If Stored Indoors, Detach and Leave Cylinder Outdoors.
Cover must be removed when burn is in operation. Minimum Clearance
From Unit To Combustible Construction: 48"(121.9cm) from the
top;72"(182.9cm) from all sides and back. Manifold Pressure: 2.74kpa
Min. gas supply for input adj:25PSI
Max. gas supply:_250_PSI
ANSZ21.97-2017·CSA241-(2017), Outdoor Decorative Gas Appliances. Do
not connect to a remote gas supply.
For Installation on[or over]Noncombustible Floors only.
WARNING: Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.
An LP-cylinder not connected for use shall not be stored in the vicinity
of this or any other appliance.
WARNING: improper installation, adjustment, alteration, service or
maintenance can cause property dangers oral injury or loss of life,
property damage. Refer to the owner's information manual provided
with this appliance, installation and service must be performed by
qualified technician.
CAUTION: The gas pressure regulator provided with this appliance
must be used. This regulator is set for an outlet pressure of 11 inches
water column.
The gas supply must be turned off at the propane gas supply cylinder when
this appliance is not in use.
24
DANGER
CARBON MONOXIDE HAZARD
This appliance can produce carbon
monoxide which has no odor.
Using it in an enclosed space can kill you.
Never use this appliance in an enclosed
space such as a camper, tent car or home.
The instruction manual contains important information necessary for the
proper assembly and safe use of the appliance. Read and follow all
warnings and instructions before assembling and using the appliance.
Trouble Shooting
PROBLEM CAUSE
Igniter pin and burner are wet
Igniter battery is incorrectly
inserted.
Igniter pin cracked or broken
Appliance won't light
Electrode wire is loose or
disconnected
Electrode wire is shorting
between valve and igniter pin
No gas flow
Regulator is not fully connected
to the tank
Gas flow is obstructed
Burner will not light
Spiderwebs or insect nest in the
using a match
venturi (end of burner tube)
Burner ports are clogged
CORRECTIVE ACTION
Wipe dry with a cloth
Check that battery is correctly
inserted
Ask qualified technician for help.
Reconnect wire to the igniter box,
located inside the table base
behind the igniter button
Ask qualified technician for help.
Check if gas cylinder is empty. If
yes, replace.
Check LP tank connection.
Check hose for bends or kinks
Clean the venturi
Insert an opened paperclip into each
of the burner ports to clean them.
Ensure that the appliance is off and
all parts are cooled before
attempting to clean the burner ports
25