Publicité
Commande du système d'éclairage
Une fois le
ColorSource comprend de nombreuses options de commande de l'éclairage.
Cette section explique comment commander les
Remarque:
commande supplémentaires peuvent être disponibles. Ces paramètres peuvent inclure la couleur,
la
position
Channels
A channel is the control used by the console to operate a dimmer, a group of dimmers, a dimmer and a
device, or a complete moving light fixture.
Channels need to be associated with an address in
Channel Counts
The ColorSource 20 can control up to 20 channels in simple mode, and 40 in complete.
The ColorSource 40 can control up to 40 channels in simple mode, and 80 in complete.
Setting the Operating Mode
Choose Simple or Complete mode on the
Fader Pages
Simple Mode offers one page of faders to control the first 20 or 40 channels, depending on the
model.
Complete Mode offers two pages of faders to control all the available channels, 40 or 80 depending
on the model.
Working with Dimmers / Intensity
Channels can be controlled in several different ways:
The faders, when in
Depending on the chosen operating mode: Complete or Simple, there are one or two pages of chan-
nels that the faders can control. In Complete Mode toggle the Channel button to access each of the
pages.
You can use the touchscreen and select channels directly on the
used to assign an intensity level.
In complete mode, you can use the
In complete mode, channels can also be controlled by the playbacks, sequences, and cues. In
simple mode, channels can be controlled by four playbacks.
Selected Channels
To make changes to channel values, a channel must be selected. Selection is indicated by a thick green
border around the channel cell on the Stage Map and a lit LED beneath the channel fader. Selection can hap-
pen in a number of ways:
Commande du système d'éclairage
patching
effectué, vous pouvez commencer à piloter votre système d'éclairage. La console
En fonction des types de projecteurs que vous avez patchés, des paramètres de
(focus), le
faisceau
channel
mode, can be used to control a channel's intensity.
Note:
The second page of channels is only available when channels have been patched
on that page (above 21 or 41, depending on the console model).
circuits
et définir les paramètres.
et les
commandes de
lampe.
patch
for there to be output.
Setup>Settings>Basic
keypad
to select a channel and assign an intensity level.
screen.
stage
map. The
wheel
can then be
21
Publicité
