Uline H-10216 Mode D'emploi page 5

NOTE: Each training table includes two sets of
ganging brackets (K). Each ganging bracket
set consists of two hooks.
1. With a second person, place assembled table
upside down with holes facing up.
2. On one side of the tabletop, install two hooks in the
pre-drilled holes located on each corner using eight
ST3.5 x 35 mm wood screws (L). Tighten using Phillips
screwdriver. Repeat on opposite side. (See Figure 12)
3. Repeat steps 1-2 on remaining table(s).
(See Figure 12)
4. Move tables together and connect using ganging
brackets. (See Figure 13)
Figure 13
Ganging Brackets (K)
Open
PAGE 5 OF 15
JOINING TABLES WITH GANGING BRACKETS
Locked
1-800-295-5510
Figure 12
1
K
uline.com
L
K
0623 IH-10216