Ryobi PCL480 Manuel D'utilisation page 9

APPLICATIONS
You may use this product for the purposes listed below:
 Carving, engraving, etching, polishing, cleaning, removing
rust, sanding, cutting, grinding, sharpening, drilling, and
routing
KEY HOLE HANGER
See Figure 3, page 13.
To mount the rotary tool console, use the key hole hanging
feature. Screws should be installed so that the center
distance is 2.5 in.
ACCESSORY STORAGE
See Figures 4 - 5, page 13.
The collet wrench and frequently used accessories can be
stored using the accessory storage.
INSTALLING/REMOVING BATTERY PACK
See Figure 6, page 14.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be in the off position
when not in use or carrying at your side.
QUICK-CHANGE COLLET
See Figures 7 - 8, page 14.
NOTE: The tool ships with a preinstalled collet that is
machined to precision tolerances to fit accessories with
1/8 in. diameter shanks. When installed, the quick change
collet allows the user to change accessories without tools
and without removing the collet from the shaft. The quick
change collet is not compatible with 1/16 in. shanks.
OPERATION
To remove/install the quick change collet:
 Remove the battery pack from the tool.
 Depress and hold the spindle lock button and rotate the
shaft by hand until the spindle lock engages the shaft,
preventing further rotation.
 With the spindle lock engaged, place the included 3/8 in.
wrench on the bottom threaded end of the quick-change
collet and turn counterclockwise to loosen. Continue
turning counterclockwise to remove the collet from the
tool.
 Remove the quick-change collet.
 To install, engage the spindle lock. Place the quick-
change collet on the shaft and begin threading on by
hand until there is resistance. Then use the included 3/8
in. wrench on the bottom threaded end of the collet and
rotate clockwise until tightly secured.
WARNING:
Always use the collet which matches the shank size of the
accessory you plan to use. Never force a large diameter
shank into a collet. The accessory should fit smoothly into
the collet, but you should be able to tighten the accessory
firmly and securely with the quick-change collet.
INSTALLING/REMOVING ACCESSORIES
See Figures 7 - 8, page 14.
To install:
 Remove the battery pack from the tool.
 Choose an accessory that fits the collet and is suitable
for the application you are attempting.
 Ensure the quick-change collet is securely installed on
the shaft.
 While depressing the spindle lock, use your hand to
loosen the collet by rotating the sleeve counterclockwise.
 Insert the shank of the accessory into the collet until the
shank bottoms out, then pull it out 1/16 in. to allow for
expansion when the accessory gets hot.
 Rotate the collet sleeve clockwise until clicking stops and
the accessory shank is gripped by the collet.
NOTE: If sleeve cannot be tightened or loosened
sufficiently by hand, use the included 3/8 in. collet wrench
on the top hexed area of the collet. Turn clockwise to
tighten or counterclockwise to loosen.
9 — English