orangemarine W700 Serie Manuel D'utilisation page 33

V OPERATING
1. During operating, if the circuit breaker bounces it means the motor is overloaded.
After about 10 seconds, press the button to reset.
2. Pay out the rope and chain approximate 2~3 times the water's depth for a firm
casting while being anchored.
3. Keep limbs, fingers, clothing and hair clear of the windlass and anchor to avoid
possible personal injury during operation.
4. Tie the anchor rope firmly to the bollard when the anchor is cast and the boat is
moored. Do not allow the windlass to take the force of a boat's drag. If using all
chain, a chain stopper is necessary between the bow roller and windlass to take
the force off the boat's drag.
5. When retracting, untie the rope from the bollard. Then move the boat to the
position just above the anchor by boat's engine power(not by windlass's power)
and switch up the windlass to lift it back. When the anchor approach the bow roller,
slow down the roll in by pausing the switch.
32 ENG