Kenwood SJM150 Serie Mode D'emploi page 3

All manuals and user guides at all-guides.com
key
spout
finger pad
flip top lid
lid release button
water level windows
on/off switch with indicator light
360° powerbase
cord wrap
filter
a clips
b compartment
c central divider
d bypass
to use your kettle
1 Fill the kettle through either the
spout or lid. To open the lid, press
the lid release button. The water
level must be between 'MAX' and
1 cup (200-250mls).
Be economical: do not boil more
●
water than you need.
To improve the quality of your drinks
●
always use fresh water.
Empty the kettle after each use.
●
2 Check the lid is closed. Close the lid
by pushing down on the finger pad
area .
3 Plug in and switch on. The indicator
light will come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
If you experience problems
●
with your kettle switching on
and off during use or
switching off before boiling,
check that the flat element is
free from scale - see
"descaling".
Your kettle is fitted with a filter to
●
hold back limescale particles.
If you find drops of water under your
●
kettle, don't worry - it is just
condensation.
boil-dry protection
If you switch on with too little water,
●
your kettle will cut out automatically.
Switch off, remove from the
powerbase and let it cool down
before re-filling. When it has cooled
down, the switch will reset itself.
using the kettle with the
1 Ensure the
into place correctly.
2 Pour the water into the
compartment until level with the
top of the central divider
cup measure. Adjust your fill rate to
match your required cup measure.
If the is fitted and you wish
●
to measure more than 1 or 2 cups,
pour the water directly into the
bypass opening .
care and cleaning
Before cleaning, unplug your kettle
●
and let it cool down.
the outside and powerbase
Wipe with a damp cloth, then dry.
●
Do not use abrasives - they will
scratch the metal and plastic
surfaces.
the inside
Even though your kettle comes with
●
a filter, you still need to clean the
inside (and the filter) regularly.
Lift the out using the central
●
divider .
Wash in warm soapy water, dry and
●
refit by clipping back into position.
the filter
1 Open the lid.
2 Slide the filter out .
3 either rinse under the tap or use a
soft brush.
or when descaling your kettle, drop
the filter in too. Rinse thoroughly.
4 Slide the filter back in to refit.
3
is clipped
for a 1