Honeywell OPTI-PRO CL3+ Notice D'utilisation page 6

EN
THESE INSTRUCTIONS ARE FOR EXPERIENCED PERSONNEL, TRAINED AND FAMILIAR WITH WEARING BREATHING
APPARATUS.
CE regulations apply to full equipment in the CE configurations certified by the notified bodies that have conducted the EC
type examinations.
Failure to comply with this procedure immediately invalidates the CE marking.
To find out all the approved configurations, refer to the configuration tables, available on request.
HONEYWELL RESPIRATORY SAFETY PRODUCTS is continuously endeavouring to improve all its products and the equipment
supplied is subject to change without notice. Consequently, the information, illustrations and descriptions provided in this
document may not be used as a reason to demand the replacement of equipment.
Being in possession of these instructions does not automatically authorise the holder to use breathing apparatus; only
appropriate training will enable safety procedures to be followed.
HONEYWELL RESPIRATORY SAFETY PRODUCTS accepts no liability if the recommendations contained in this document are
not followed.
The recommendations in boxes have the following meanings:
Failure to follow the instructions in boxes could seriously damage the equipment used and put
the user in danger.
Failure to follow the instructions in boxes could lead to incorrect use of the equipment and result
in damage to the equipment.
PROTECTION AND USAGE CATEGORIES
OPTI-PRO CL3+ masks comply with the requirements of the EN136 CL3 as well as with the requirements of the EN 137:2006 for flame
engulfment resistance.
This equipment is designed to protect the user's respiratory tracts against toxic gas, dust or aerosols or when the atmosphere is poor in
oxygen (less than 17%).
OPTI-PRO CL3+ masks are intended for use with Honeywell self-contained open-circuit compressed air breathing apparatus approved
in accordance with the requirements of European standards.
OPTI-PRO CL3+ masks with helmet attachement are intended for use with CE certified fire brigade helmets type F1, F1S, F1SF and
F1XF.
These instructions are only intended for use with CE certified OPTI-PRO CL3+ masks complying
with the European Standard EN136 CL3 and EN 137 CL3.
The OPTI-PRO CL3+ masks must only be used in accordance with the instructions given here.
Incorrect use might result in danger to life or limb.
LIMITATIONS OF USE
• The OPTI-PRO CL3+ mask should never be used on its own. It must be used with Honeywell CE-certified respiratory protection
equipment.
The air supplied by the associated equipment must be breathable quality.
•
Limitations of use of the entire respiratory protective equipment depend on the actual device attached. Please consult the user
•
manual delivered with this equipment for details.
This device is not designed to be used in oxygen-enriched or explosive atmospheres.
•
According to the environment the device is used (fire-fighting, mining, industry ...), it is mandatory to refer to official safety
•
regulations in force covering the specific circumstances for use.
• Please consult the supplier, if you have any doubt as to whether the respirator is suitable for the work at hand.
INSTRUCTIONS FOR USE
Do not use the mask if it is not fully airtight. See the maintenance instructions.
•
Make sure that your hair is not caught between the mask and your face. The sealing of the mask is also affected by
•
beards, whiskers or temples of glasses.
Always make sure that the breathing apparatus attached to the mask is suitable for the work in hand.
•
During normal use, breathe slowly and regularly.
•
• Immediately leave the contaminated area if the mask or the attached respiratory equipment should fail.
• Do not take the mask off before leaving the contaminated zone.
When removing the mask, take all necessary precautions to avoid inhaling the dust or contaminant retained on the
•
external surface of the mask.
Unpacking instructions
• Carefully remove the mask from the packaging.
• Check that the equipment is complete and free of damage. Immediately contact your supplier in case of damage or missing items.
The mask must not be used if it is damaged or incomplete.
All manuals and user guides at all-guides.com
IMPORTANT
IMPORTANT
NOTE
EN-1