Publicité
Les langues disponibles
Les langues disponibles
A
3 To remove the back panel (B), remove bolt
(C).
C
B
4 Proceed in reverse order to re-assemble.
32
Instructions for Removing the Supports and
the Flat Catalytic Panels.
1 Remove the accessories from inside the
oven.
2 Ease out the supports (A), releasing them
from the bolt (B)
A
B
3 Undo the bolt (B), which releases the flat
catalytic panels.
B
4 To disassemble the back panel (C), remove
screw (D).
D
C
C
5 Proceed in reverse order to re-assemble.
Caution
The flat catalytic panels can be used both
ways round, lengthening their life. When they
are worn, they must be used the other way
round inside the oven with the new enamelled
surface towards the inside of the oven.
Cleaning the Oven Exterior
and Accessories
Clean the outside of the oven and the
accessories with warm soapy water or with a
mild detergent.
Caution
Never
use
metallic
scouring
pads
commercial or scouring powders that could
scratch the enamel. For stainless steel
surfaces, proceed with care and only use
sponges or cloths that cannot scratch them.
To clean the outside of the oven do not attempt
to remove the controls, as for this, the oven
has to be first removed from the kitchen unit.
.
Cleaning the Oven Door
Depending on the oven model, you can remove
the door to simplify its cleaning. To do so:
1 Open the door.
2 Completely turn the two clips (A).
A
or
33
Publicité
