Publicité
Les langues disponibles
Les langues disponibles
USING THE SPRAY WAND TRIGGER
See Figure 12.
For greater control and safety, keep both hands on the
trigger handle at all times.
Pull back and hold the trigger to operate the pressure
washer.
Release the trigger to stop the flow of water through the
nozzle.
To engage the lock out:
Push up on the lock out until it clicks into the slot.
To disengage the lock out:
Push the lock out down and into its original position.
To use the spray wand, start with the nozzle 1-2 ft. away
from the cleaning surface. Carefully approach the surface
just until the desired level of cleaning is achieved. If the spray
is too close it can damage the cleaning surface.
ABRASIVE
Concrete, Brick, Masonry
Siding, Gutters, House
Fencing, Deck, Patio
Lawn Equipment, Boat, RV
OPERATION
NOZZLE SELECTION GUIDE
0º Red
GENTLE
Recommended Nozzle
Page 12 — English
SELECTING THE RIGHT NOZZLE FOR THE
JOB
See Figure 13.
Each of the nozzles has a different spray pattern. Before
starting any cleaning job, determine the best nozzle for the
job. Refer to the Nozzle Selection Guide for more informa-
tion about which nozzle to choose.
WARNING:
NEVER change nozzles without locking the lock out on
the trigger handle and NEVER point the wand at your
face or at others. The quick-connect feature contains
small springs that could eject the nozzle with some force.
Failure to follow these instructions could result in serious
personal injury.
HIGH PRESSURE
(NO SOAP WHEN USING THESE NOZZLES)
25º Green
Use With Caution for Certain Applications
LOW
PRESSURE
(FOR SOAP OR
GENTLE RINSE)
40º White
Blue Soap Nozzle
Publicité
