Publicité
Les langues disponibles
Les langues disponibles
EN
15 Troubleshooting
FAULT
Mobile air
conditioner does
not start.
The mobile air
conditioner is
not operating
with the
expected
effectiveness.
Insufficient
cooling.
Air is not blown
out.
Operating
noises.
Water runs out.
Page | 34
POSSIBLE CAUSES
Mains plug is not plugged
into the plug socket.
Display "Full" is lit.
Room temperature is lower
than the set temperature.
Doors and/or windows are
not properly closed.
There are additional heat
sources in the room.
Temperature is set too
high.
Air inlet or outlet is
blocked.
Air filter or air outlet is
blocked.
The appliance is not
standing on a level and
stable surface.
Air filter or air outlet
blocked.
Appliance makes "flowing"
noises.
Water drain hose has come
loose or is damaged.
Water drain hose is
blocked.
Drain hole not properly
closed. Drainage plug is
damaged.
MEASURES
Check whether the mains plug
has been plugged in correctly.
Empty the water tank.
Lower the set temperature.
Close all doors and windows,
etc. through which warm air
may enter.
Remove heat sources, if
possible.
Lower the set temperature.
Remove objects from the air
inlet/outlet. Clean the air filter
and air outlet. Maintain the
specified minimum clearances.
See above.
Place the appliance on a level
and stable surface.
See above.
Flowing noise of the refrigerant.
No measures necessary.
Inspect the water drain hose for
damage and check for correct
installation; replace or install
correctly, as necessary.
Remove any obstacles and
straighten the water drain hose.
Check whether:
-
The drain hole is properly
closed.
-
The plug is damaged.
Publicité
