Publicité
Les langues disponibles
Les langues disponibles
3. Re-installing the filter
After cleaning, assemble in the sequence of"exhaust filter - lint
filter- exhaust vent shroud",align the recesses in the center with the
projection in the center of the drum. Make sure that it is firmly
inserted (as shown in figure 3).
Figure 3
Cleaning of the Air Intake Filter
The filter should be cleaned once a month.
Remove by pulling outwards holding the upper and lower ends of the
air intake shroud. Remove the filter inside the shroud and clean it
with a soft brush, Reassemble and install as before.
Air Intake Shroud
Slightly push upwards with your thumb until the
latch hook disconnects, then remove.
Note: The filter fixed in
the bottom of the
drum should also be
cleaned with a soft
brush.
Air Intake Filter
20
Cleaning the interior & exterior of the Dryer
Do not wash directly with water.
Do not use thinner, gasolene or alcohol.
Do not use any type of spray cleaner when cleaning the interior. If
dryer drum becomes stained, clean the drum with a damp cloth.
Remove any residue before drying the next load.
Clean cabinet with mild soap and water. Do not use harsh or abrasive
cleaners, this could damage the dryer.
WARNING: Regularly clean the lint trap
READ THE INSTRUCTIONS
CAUTION! HOT SURFACE
21
EN
Publicité
