Costway ES10166US Manuel De L'utilisateur page 10

Fig. 5
The appliance shall not be exhausted into a chimney, a wall, a
ceiling, an attic, a crawl space, or a concealed space of a building.
Only rigid or flexible metal duct shall be used for exhausting.
In Canada, that only those foil-type flexible ducts, if any, specifically
identified for use with the appliance by the manufacturer shall be
used. In the United States, that only those foil-type flexible ducts, if
any, specifically identified for use with the appliance by the
manufacturer and that comply with the outline for Clothes Dryer
Transition Duct, Subject 21 58A, shall be used.
In Canada, that the exhaust duct shall be 102 mm/4" in diameter.
In the United States, the required exhaust duct diameter.
That the total length of flexible metal duct shall not exceed 2.4
m/7.9 ft.
That the duct shall not assembled with screws or other fastening
means that extend into the duct and catch lint.
18
Maintenance
Cleaning the Lint Filter
Please unplug the power cord prior to any cleaning. The lint filter
must be in place whenever drying. It must be cleaned before each
use.
1. Removing the filters
Remove by pulling outwards with fingers, inserted into the four
holes around the exhaust vent shroud. The filter is in 3 parts:
Exhaust vent shroud, lint filter and exhaust filter (as shown in
figure1)
The filter fixed in the
bottom of the drum
Exhaust Lint Exhaust
vent shroud filter Filter
2. Cleaning the filter
Separate"exhaust vent shroud" ,"lint filter"and "exhaust filter".
Clean the lint on the lint filter and exhaust filter with a soft brush or
vacuum cleaner.
Do not damage the filters (as shown in figure 2)
Lint Filter
Linfs
Figure 1
Exhaust Filter
Dust Cleaner
Figure 2
19
EN