Publicité
Les langues disponibles
Les langues disponibles
18 After Finishing Work
Cutting side of hedge
► If you have to cut at a certain distance from the hedge
(flowerbed): Set the cutting attachment to a suitable
angle.
► Swing the cutting attachment from the bottom of the hedge
upwards in a controlled arc (see illustration above).
► Lower the nose of the cutting attachment, move along the
hedge and swing the cutting attachment up again in a
controlled arc.
► Cut the other side of the hedge in the same way.
► If cutting performance deteriorates: Sharpen the cutting
blades.
Cutting top of hedge
► Hold the cutting attachment at an angle of 0° to 10° as you
move the cutting attachment horizontally, using both sides
of the cutting attachment (see illustration above).
0458-185-8221-A
► If cutting performance deteriorates: Sharpen the cutting
blades.
Cutting overhead
WARNING
Working above shoulder height can be tiring. To reduce the
risk of injury from fatigue, never hold the machine with your
rear hand on the control handle above shoulder height. Set
the adjustable cutter blades to the most suitable angle so
that the unit can be held at a lower, less tiring position while
providing adequate reach. Take frequent breaks.
► Set the cutting attachment to a suitable angle.
► Hold the cutting attachment at an angle of 0° to 10° as you
move the cutting attachment horizontally, using both sides
of the cutting attachment (see illustration above).
► If cutting performance deteriorates: Sharpen the cutting
blades.
18 After Finishing Work
18.1 Preparing for Transportation or Storage
WARNING
To reduce the risk of personal injury from unintended
activation or unauthorized use, switch off the motor, ensure
the cutting blades have stopped and remove the battery
before transporting the hedge trimmer or putting it down.
English
31
Publicité
