Louver Direction - Toshiba Carrier MMY-MAP0726FT6P-UL Manuel Du Propriétaire

Cooling / Heating operations
■
• When the outdoor temperature goes out of the
operable range, cooling or heating operation may
not be performed in order to protect the equipment.
In this case, " " goes on.
• If the outside temperature decreases during
operation, the fan of the outdoor unit may stop.
Characteristics of heating
■
• Air does not come out immediately after heating
starts. Heated air comes out after 3 to 5 minutes
(depending on the room/outside temperatures), after
the indoor heat exchanger warms up.
• When the outside temperature increases, the
outdoor unit may stop.
Prohibition of NFC function
■
(NFC for SMMS wave tool)
NFC communications is enabled at the time of
shipping from the factory, but it is possible to disable
the test run and the automatic address setting with a
smart phone.
Please consult dealer from where you purchased it for
more details.
17-EN
Carrier 1122002001 EN FR.indb 9 Carrier 1122002001 EN FR.indb 9
– 9 –
8

Louver direction

NOTE
• To improve the cooling/heating performance,
change the louver angle for each operation.
• This function is not available for duct type units.
The characteristics of air: Cool air falls, and warm
air rises.
CAUTION
Point the louver horizontally during cooling
If pointing downward for cooling, dew may form on
the surface of the air discharge or louver and may
drop down.
NOTE
• If pointing horizontally for cooling, dew may form
on the surface of the cabinet or louver and may
drop down.
• If pointing horizontally for heating, the room
temperature may be uneven.
• Do not handle the louver manually.
Doing so may cause a failure.
Use the SWING/FIX button on the remote control
to adjust the angle.
4-way cassette type,
■
Compact 4-way cassette type,
Ceiling type
◆ To set the louver direction
1
Push the button during running.
The louver direction changes with each push of
the button.
▼ For heating
Point the louver downward.
If not pointing downward, hot
air may not reach the floor.
Initial setting
For cooling
▼
Point the louver horizontally.
If pointing downward, dew
may form on the surface of
the air discharge port and
Initial setting
may drop down.
▼ For fan
Select a wind direction.
Initial setting
◆ To start swinging
1
Push the button repeatedly to set the
louver direction to the lowest position, then
push again.
The SWING indicator is displayed and the
louver begins swinging.
▼ In all operations
Repeat
6/22/16 2:10 PM 6/22/16 2:10 PM
18-EN