Frico Elztrip EZ115 Mode D'emploi Et Instructions De Montage page 11

GB
Circuit breaker
If the installation is protected by means
of a circuit breaker and it trips when the
appliance is connected, this may be due to
moisture in the heating element. When an
appliance containing heating element has not
been used for a long time and is stored in a
damp environment, moisture can enter the
element. This should not be seen as a fault,
but is simply rectified by connecting the
appliance to the mains supply via a socket
without a circuit breaker, so that the elements
dry. The drying time can vary from a few
hours to a few days. As a preventive measure
the unit should occasionally be run for a short
time during long operation pauses. At large
installations, there should be a division on
several circuit breakers.
Maintenance
If the heater is used in rooms where there are
aerosols, lacquer, solvents and similar,
this can cause a coating on the panels and
discolour them. The output is not affected.
10
Elztrip EZ 100
Safety
• Do not touch surface of heater when in
use!
• The unit must not be covered fully
or partially with clothes or similar
materials, as covering can result in a risk
of fire!
• This appliance is not intended for use
by children and persons with reduced
physical, sensory or mental capabilities,
or a lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by an individual responsible
for their safety. Children should be
supervised to ensure that they do not play
with the appliance.