Publicité
Les langues disponibles
Les langues disponibles
Problem
The compressor operates
continually.
Water flows into the refriger-
ator.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead
to the desired result, call the
nearest brand-mark service.
8.2 Replacing the lamp
Disconnect the plug from the mains
socket.
1. Remove the screw from the lamp
cover.
2. Remove the lamp cover (refer to the
illustration).
Possible cause
Temperature is set incorrect-
ly.
Many food products to be
frozen were put in at the
same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The appliance is not level-
led.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are
stored at the same time.
The door has been opened
often.
3. Replace the used lamp with a new
lamp of the same power and
specifically designed for household
ENGLISH
Solution
Refer to "Operation" chap-
ter.
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Clean the water outlet.
Make sure that food prod-
ucts do not touch the rear
plate.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces-
sary.
11
Publicité
