Workshop WS0500VA0 Mode D'emploi page 9

3. Dust Collection Bags
a. The available Dust Collection Bag is
catalog number WS32090F.
b. The Dust Collection Bag is intended
for cleaning up dry debris ONLY.
c. If the debris being picked up has any
moisture, the bag will absorb the
moisture and may deteriorate very
quickly, making the bag non-
functional.
d. If you are using your vacuum to pick
up fine dust, the Dust Collection Bag
will make cleanup easier. Note: Dust
Collection Bag MUST be used in
conjunction with a Filter Bag or
Pleated Paper Cartridge Filter.
e. Directions for Installation and
Removal of Dust Collection Bags are
printed on the bags.
Emptying the Drum
WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before emptying
the drum.
1. Pull the flexible latches outward on
each side of the lid to release from the
drum.
2. While holding the latches out, lift the
top assembly up and away from the
drum.
3. Dump the drum contents into the
proper waste disposal container.
WARNING: To reduce the risk of
back injury or falls, do not lift a Vac
heavy with liquid or debris. Scoop
or drain enough contents out to
make the Vac light enough to lift
comfortably.
OPERATION
(continued)
Blowing Feature
Your Wet/Dry Vac features "Full Blowing".
It can blow sawdust and other debris.
Follow the steps below to use your Vac
as a blower.
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a Blower.
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
1. Locate blowing port of your Wet/Dry
Vac.
2. Insert the tabbed end of hose into the
blowing port of the Vac.
3. Turn Vac on and you are ready to use
your Vac as a blower.
Blowing
Port
Locking
Hose
9