Télécharger Imprimer la page

Hilti TE 6-CL Notice D'utilisation Originale page 23

Masquer les pouces Voir aussi pour TE 6-CL:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
2. Slide the depth gauge from the front into the opening provided in the side handle. Adjust the depth gauge
to the desired drilling depth.
3. Release the release button.
▶ The depth gauge is locked.
6.3
Fitting the accessory tool
Lightly grease the connection end of the accessory tool.
Use only genuine Hilti grease. Using the wrong grease can result in damage to the tool.
1. Push the accessory tool into the tool holder as far as it will go, turning it and applying light pressure until
it engages with an audible click.
2. After fitting the accessory tool, grip it and pull it in order to check that it is securely engaged.
▶ The product is ready for use.
7
Operation
WARNING
Damaged power cords are a safety hazard! If the supply cord or extension cord is damaged while work
is in progress, immediately disconnect the device and the cord from the electricity supply. Do not touch the
damaged part of the cord.
▶ Regularly check all supply cords. Replace defective extension cords. Have damaged power cords
replaced by a qualified specialist.
Use of a ground fault circuit interrupter (residual current device, RCD) with a maximum tripping current of
30 mA is recommended.
7.1
Forward / reverse
▶ Set the forward / reverse selector switch to forward or reverse rotation.
7.2
Drilling without hammering
▶ Set the function selector switch to the "Drilling without hammering" position
7.3
Drilling with hammer action (hammer drilling)
▶ Set the function selector switch to the "Hammer drilling" position
7.4
Chisel positioning
▶ Set the function selector switch to the "Chisel positioning" position
▶ The chisel can be adjusted to 18 different positions (in 20° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
7.5
Chiseling
6
CAUTION
Risk of injury Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel positioning". Turn the function selector
switch until it engages in the "Chiseling"
▶ Set the function selector switch to the "Chiseling" position
7.6
Removing the accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
*2266070*
4
5
6
6
position.
4
2266070
6
.
.
.
.
English
17

Publicité

loading