Hilti TE 6-CL Notice D'utilisation Originale page 21

3 Description
3.1 Product overview
3.2 Intended use
The product described is an electrically powered rotary hammer. It is designed for drilling in concrete,
masonry, drywall panel, wood, plastic and metal. The rotary hammer can also be used for light chiseling
work on masonry and surface finishing on concrete.
▶ The power tool may be operated only when connected to a power supply providing a voltage and
frequency in compliance with the information given on its type plate.
3.3 Items supplied
Rotary hammer, side handle, depth gauge, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group | USA: www.hilti.com
4 Technical data
4.1 Rotary hammer
For details of the rated voltage, frequency, current and/or input power, refer to the country-specific
type identification plate.
When powered by a generator or transformer, the generator or transformer's power output must be at least
twice the rated input power shown on the rating plate of the power tool. The operating voltage of the
transformer or generator must always be within +5% and -15% of the rated voltage of the power tool.
Weight in accordance with EPTA procedure 01
Ø Hammer drill bits
Ø Drill bits for wood
Ø drill bits for metal
4.2 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This can significantly reduce exposure over
the total working period.
*2266070*
1
2266070
Tool holder with dust cap
@
Depth gauge
;
Function selector switch
=
Control switch
%
Grip
&
Forward / reverse switch
(
Side handle
)
TE -6-CL
3.2 kg
5 mm ... 28 mm
3 mm ... 20 mm
≤ 13 mm
English 15