Publicité
Les langues disponibles
Les langues disponibles
Note:
H
is a button with no function.
Warning: Changes or modifications to this unit not
expressly approved by the party responsible
for compliance could void the user's authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult an experienced radio/TV technician for help.
12
Temperature Limiting Control
This log heater is equipped with a Temperature Limiting Control.
Should the heater reach an unsafe temperature, the heater will
automatically turn OFF. To reset:
•
Unplug the power cord from the outlet.
•
Turn the Power Switch on the CONTROL PANEL to OFF. Wait
at least 30 minutes. Lower electric firebox internal temperature.
•
Inspect the fireplace to make sure no vents are blocked, or
clogged with dust or lint. If they are, use a vacuum to clean the
vent areas.
•
With the Power Switch in the OFF position, plug the power cord
back into the outlet.
If it switches off again, UNPLUG THE HEATER RIGHT AWAY!
Have the outlets, wiring, and breaker box inspected by a
professional. Make necessary repairs before using the heater.
4. CARE AND MAINTENANCE
•
ALWAYS turn the appliance OFF and unplug the
power cord from the outlet before cleaning,
performing maintenance, or moving this fireplace.
Failure to do so could result in electric shock, fire, or
personal injury.
•
NEVER immerse in water or spray with water. Doing
so could result in electric shock, fire, or personal
injury.
•
Risk of electric shock! DO NOT OPEN! Replace parts
contact our customer service team for help first !
13
Publicité
