Grozone Control OSWDN Guide De L'usager page 4

All manuals and user guides at all-guides.com
The OSWDN On/Off switcher features two 120V outputs to supply
power to equipment either during the day only or during the night only.
This plug-in module is similar to Grozone OSW except that OSW Trigger
Cord has been removed and replaced by a photocell; therefore, the On/
Off outputs are controlled by day-night conditions, instead of being con-
trolled by a voltage applied to the trigger cord.
1– For DAY/NIGHT Control : if you need to control your equipment during
the DAY or during the NIGHT only, then plug your equipment as follows:
- In the upper output to turn the equipment «On during the DAY ONLY»
- In the lower output to turn the equipment «On during the NIGHT ONLY»
2– TO FIX a DAY/NIGHT Detection Problem : you can also use this module
to connect a controller without a photocell, or a controller having problem
detecting day or night conditions correctly in the grow room : the OSWDN
has a day-night sensitivity level setting that allows you to define the
amount of light needed to detect a day or a night condition meeting your
specific grow room conditions.
•
Two 120V outputs : upper output is ON while lower output is OFF
and vice versa.
•
Total current for both outputs : 15A maximum.
•
Photocell in a clear plastic dome to allow light detection 360°.
•
Day-night level setting on the side of the module, to set the pho-
tocell sensitivity to your grow room conditions.
•
ETL LISTED
4
4
4
GENERAL DESCRIPTION
TYPICAL USE
SPECIFICATIONS