Furrion ARCTIC FCR08DCGTA Serie Manuel D'utilisateur page 7

NOTE: If securing a refrigerator in a cabinet with a sidewall
vent, no additional mounting or sealing is necessary on the
rear of the appliance.
Fig. 1 Fig. 1
Fig. 2 Fig. 2
3. Install the air vent and tighten the screws. (Fig. 3)
Fig. 3 Fig. 3
Reversing the Door Swing (Optional)
Your refrigerator is ordered as either a left or right open swing
from the factory, you may change the door swing direction as
required.
1. Disassemble the freezer door by removing the Hinge A
fixing screws. (Fig. 4) Remove the Hole Plastic Cover
Plugs from the left side of the refrigerator and set aside for
future use.
Hole Plastic Cover Plugs
Hinge A
Fig. 4 Fig. 4
2. Disassemble the Refrigerator Door by removing the Hinge
B and Hinge C fixing screws. (Fig. 5)
Hinge B
Hole Plastic
Cover Plugs
Hinge C
Fig. 5 Fig. 5
3. Reverse the parts of Freezer Door Lock Cover, Metal
Bracket, Plastic Bushing, Freezer Door Lock, Lock Fixing
Block to the opposite side respectively. (Fig. 6)
NOTE: The Metal Bracket is only applicable to models
FCR08DCGTA-BL/BR and FCR10DCGTA-BL/BR.
Lock Fixing Block
Freezer Door Lock
Fig. 6 Fig. 6
4. Remove the Refrigerator Door Lock Cover (right) and
save it for future use. Change Refrigerator Door Lock and
- 6 -
Plastic Bushing
Freezer Door Lock Cover
Metal Bracket
CCD-0005518 Rev: 01-10-23