Publicité
Les langues disponibles
Les langues disponibles
9 BOILER OPERATION
9.1 STARTING THE BOILER
To start the boiler hold the
Automatic boiler ignition: the boiler comes with an automatic device that starts the pellet boiler without using
or drying of certain materials used. This phenomenon will gradually disappear.
9.2 MODIFYING THE PARAMETERS
power supply.
9.3 SWITCHING OFF
To switch the boiler off hold the
To start the boiler again it's recommended to wait for the boiler to cool down completely.
The boiler should only be switched off following the procedure described above. Never switch the boiler off by
unplugging it from the power supply.
9.4 OPERATION WITH ROOM THERMOSTAT
When the boiler is controlled by an external thermostat (or timer thermostat), the installer must have set
output (that is, the boiler attempts to maintain the desired temperature while minimising fuel consumption) when
reaching the set water temperature.
The boiler switches on again automatically when the temperature falls below the value set on the external
thermostat (circuit closed).
directly from the control panel.
The boiler will go off automatically even in the case the water temperature keeps growing notwithstanding the
modulation mode. In this case the boiler will ignite only if the difference between the selected and actual temperature
is over 20°C.
9.5 OPERATION WITH ROOM PROBE ON THE BOILER
The boiler can be switched on/off manually or in programmed mode.
the boiler (that is, the boiler attempts to maintain the desired temperature while minimising fuel consumption).
If the user has enabled the "Eco-mode" function under submenu
rather than modulating its output, switches off when reaching the set temperature, and switches on again
when the room temperature falls below the delta set in submenu
The desired room temperature can be set in temperature menu
[6]
Submenu
of the setup menu
for the heating system in question should be suggested by the heating system installer).
9.6 OPERATION IN COMBINATION WITH A STORAGE TANK
whether the storage tank is with or without a coil inside.
The boiler is controlled based on the temperature read by the probe in the storage tank.
When reaching the storage tank temperature set in the temperature menu
switches on again if the temperature falls below the delta set in submenu
50
USE AND & MAINTENANCE
button for several seconds.
can be used to set the desired water outlet temperature (the best temperature
button), the boiler needs to be started
[7]
of the setup menu
[7]
of the setup menu
.
the boiler switches off, and
[8]
of the setup menu
, the boiler
.
.
Publicité
