Bosch UniversalDistance 30 Notice Originale page 25

Digital laser meas-
ure
– Continuous
D)
measurement
A) When measuring from front edge. In unfavourable conditions such
as very strong lighting, a temperature greatly deviating from 20 °C
or a poorly reflecting surface, the measuring range can be restric-
ted.
B) This applies for high reflectivity of the target (e.g. wall painted
white), weak background lighting and a 20 °C operating temperat-
ure. In addition a deviation of ±0.05 mm/m needs to be taken into
account. In unfavourable conditions such as strong lighting, high
altitudes or a poorly reflecting surface, and at a 20 °C operating
temperature, the deviation can be ±4 mm. In addition, a deviation
of ±0.15 mm/m must be taken into account.
C) Only non-conductive deposits occur, whereby occasional tempor-
ary conductivity caused by condensation is expected.
D) At an operating temperature of 20 °C
The serial number (11) on the type plate is used to clearly identify your
measuring tool.
Inserting/Changing the Battery
Always replace all the non-rechargeable batteries at the
same time. Only use non-rechargeable batteries from
the same manufacturer and which have the same capacity.
When inserting the batteries, ensure that the polarity is
correct according to the illustration on the inside of the
battery compartment.
Take the non-rechargeable batteries out of the measur-
u
ing tool if you are not using it for a long time. The non-re-
chargeable batteries can corrode and self-discharge during
prolonged storage.
Bosch Power Tools
UniversalDistance
30
2.5 h
1 609 92A 8CZ | (31.03.2023)
English | 25
UniversalDistance
50
2.5 h