Sommaire des Matières pour Bell'O TRIPLE PLAY TP4452
Page 1
TP4452 FLAT PANEL TV MOUNTING SYSTEM SUPPORT DE TÉLÉVISEUR À ÉCRAN PLAT ZESTAW POD TELEWIZOR Z PŁASKIM EKRANEM КОМПЛЕКТ ПОД ТЕЛЕВИЗОР С ПЛОСКИМ ЭКРАНОМ OPTION 1 OPTION 2 OPTION 3 OPTION 1 OPTION 2 OPTION 3 OPCJA 1 OPCJA 2 OPCJA 3 ВАРИАНТ...
Page 2
BELL’O INTERNATIONAL CORPORATION WILL NOT BE RESPONSIBLE FOR FAILURE TO ASSEMBLE AS DIRECTED OR FOR THE IMPROPER ASSEMBLY, USE, OR HANDLING OF THIS PRODUCT. ! IMPROPER INSTALLATION OF THIS PRODUCT MAY CAUSE DAMAGE OR SERIOUS INJURY. BELL'O INTERNATIONAL CORPORATION CANNOT BE LIABLE FOR DIRECT OR INDIRECT DAMAGE OR INJURY CAUSED BY INCORRECT MOUNTING, INCORRECT USE, OR INCORRECT ASSEMBLY.
Page 3
D’ACHAT À DISPOSITION. BELL'O EXPÉDIERA TOUTES LES PIÈCES DE RECHANGE NÉCESSAIRES AUX ETATS-UNIS D'AMÉRIQUE CONTINENTAUX. ! LES CARACTÉRISTIQUES SONT SUJETTES À MODIFICATION SANS PRÉAVIS. Bell'O International Corps décline toute responsabilité en cas d'assemblage non conforme aux instructions ou pour l'assemblage, l'utilisation ou la manutention incorrects de ce meuble.
Page 4
DLA BEZPIECZEŃSTWA, NALEŻY STOSOWAĆ SIĘ DO PONIŻSZYCH WSKAZÓWEK: ! NIE UMIESZCZAJ NA PÓŁKACH (LUB STOJAKU NA TELEWIZOR) PRZEDMIOTÓW, KTÓRYCH MASA PRZEKRACZA MAKSYMALNY DOPUSZCZALNY LIMIT: 56,7 KG DLA TELEWIZORA ORAZ 34 KG DLA DOLNEJ PÓŁKI. ! MONTAŻ ŚCIENNY DOPUSZCZALNY JEST WYŁĄCZNIE NA ŚCIANACH ZE STELAŻEM DREWNIANYM LUB BETONO- WYCH.
Page 5
ПОЗВОНИТЕ В ОТДЕЛ ОБСЛУЖИВАНИЯ КЛИЕНТОВ НАШЕЙ КОМПАНИИ ПО ТЕЛЕФОНУ: 1 888 235 7646. ПОЖАЛУЙСТА, ПРИГОТОВЬТЕСЬ НАЗВАТЬ НОМЕР МОДЕЛИ, КОД ДАТЫ, НОМЕРА ДЕТАЛЕЙ И ИМЕЙТЕ ПРИ СЕБЕ ЧЕК ИЛИ ДРУГОЙ ДОКУМЕНТ, ПОДТВЕРЖДАЮЩИЙ ПОКУПКУ. КОРПОРАЦИЯ BELL'O ОТПРАВИТ ВАМ ВСЕ НЕОБХОДИМЫЕ ДЕТАЛИ ДЛЯ ЗАМЕНЫ НА ТЕРРИТОРИИ КОНТИНЕНТАЛЬНОЙ ЧАСТИ США.
Page 6
PARTS LIST / NOMENCLATURE DES PIÈCES / LISTA CZĘŚCI / ПЕРЕЧЕНЬ ДЕТАЛЕЙ Quantity Quantity Quantité Quantité Part / Pièce / Część / Деталь Part / Pièce / Część / Деталь Ilość Ilość Количество Количество YF11 12 mm YF12 18 mm YF13-3 28 mm YF14-3...
Page 7
PARTS LIST / NOMENCLATURE DES PIÈCES / LISTA CZĘŚCI / ПЕРЕЧЕНЬ ДЕТАЛЕЙ Quantity Quantity Quantité Quantité Part / Pièce / Część / Деталь Part / Pièce / Część / Деталь Ilość Ilość Количество Количество YF25 YF21 YF22 YF26 YF23-3 YF27 YF28 YF24-3 TV MOUNTING SCREWS / VIS DE FIXATION DE TV...
Page 8
OPTION 1: FLAT PANEL TV STAND OPTION 1: MEUBLE POUR TÉLÉVISEUR À ÉCRAN PLAT OPCJA 1: STOLIK POD TELEWIZOR Z PŁASKIM EKRANEM ВАРИАНТ 1: ПОДСТАВКА ПОД ТЕЛЕВИЗОР С ПЛОСКИМ ЭКРАНОМ NOTE: 2 PEOPLE ARE RECOMMENDED TO ASSEMBLE THIS FURNITURE. TO AVOID DAMAGE DURING ASSEMBLY, IT SHOULD BE ASSEMBLED ON A SOFT SURFACE.
Page 9
Fig. 1-2 YF13-3 YF15-3 YF14-3 YF16-3 1-4. LIFT the front frame upright, and ATTACH the Left and Right Rear Support Frames (YF15-3, YF16-3) using four 12 mm Screws (YF1) as shown above. Fully tighten all Screws. 1-4. REDRESSER le cadre avant et ATTACHER les cadres supports arrière droit et gauche (YF15-3, YF16-3) à l'aide de quatre vis de 12 mm (YF1) comme sur l'illustration ci-dessus.
Page 10
Fig. 1-3 YF16-3 YF17-3 YF11 YF13-3 YF15-3 YF12 YF14-3 1-5. ATTACH the CMS (Cable Management System) Panel (YF17-3) to the Left and Right Rear Support Frames (YF15-3, YF16-3) using four ® 35 mm Screws (YF4) as shown above. Tighten Screws fully. 1-6.
Page 11
YF16-3 YF24-3 Fig. 1-4 YF13-3 YF15-3 YF23-3 1-8. From the front, carefully PLACE the Lower Glass Shelf (YF23-3) down onto the Soft Glass Pads (YF8) along the Bottom Crossbar (YF14-3) and the Right and Left Rear Support Frames (YF15-3, YF16-3). Make sure the Glass Shelf is well supported, level, and properly in place. 1-9.
Page 12
OPTION 2: FLAT PANEL TV MOUNTING SYSTEM OPTION 2: SUPPORT DE TÉLÉVISEUR À ÉCRAN PLAT OPCJA 2: STOLIK ZE STOJAKIEM NA TELEWIZOR ВАРИАНТ 2: КОМПЛЕКТ СО СТОЙКОЙ ДЛЯ КРЕПЛЕНИЯ ТЕЛЕВИЗОРА Fig. 2-1 Fig. 2-2 YF20 YF19 YF20 (View from Rear) (Vue depuis l'arrière) (Widok z tyłu) YF18...
Page 13
Fig. 2-3 YF21 YF19 YF20 YF18 YF18 YF10 YF17-3 2-3. ATTACH the Mounting Pole (YF18) to the back of the CMS Panel (YF17-3) using four 54 mm Bolts (YF5) as shown. Tighten Bolts fully. ® 2-4. SCREW in two Tilt Adjustment Knobs (YF10) through the slots in the Tilt Bracket (YF20) and into the threaded hole in the Mounting Pole (YF18) as shown.
Page 14
MOUNTING THE TELEVISION / POSE DU TÉLÉVISEUR MONTAŻ TELEWIZORA / УСТАНОВКА ТЕЛЕВИЗОРА CAUTION: CAREFULLY DETERMINE THE CORRECT MOUNTING PROCEDURE TO PREVENT DAMAGE TO YOUR TV AND/OR BELL'O ® MOUNTING SYSTEM. ALWAYS REMOVE THE TELEVISION & COMPONENTS BEFORE ATTEMPTING TO MOVE THE STAND.
Page 15
YF22 Fig. 2-5 YF22 TVY10 TVY9 TVY12 TVY11 TVY2 TVY6 TVY4 TVY11 TVY8 TVY1 TVY3 TVY5 2-7. PLACE your TV face-down on a flat, very soft, non-abrasive surface, taking extreme caution to not damage the face of your TV. 2-8. ATTACH each Monitor Arm (YF22) to the back of your television as shown with selected Screws and Washers. Make sure that each Washer (TVY11 or TVY12) is placed between the Screw and the Monitor Arm.
Page 16
Fig. 2-6 YF22 Fig. 2-7 YF21 2-9. With the help of an assistant, carefully ATTACH the TV with Monitor Arms (YF22) to the Mounting Bracket (YF21) and SECURE the Monitor Arms using two 25 mm Screw (YF6) as shown in Fig. 2-7. Tighten Screws fully. 2-9.
Page 17
OPTION 3: STAND WITH WALL MOUNT OPTION 3: MEUBLE AVEC SUPPORT MURAL OPCJA 3: STOLIK ZE STELAŻEM DO MONTAŻU ŚCIENNEGO ВАРИАНТ 3: ПОДСТАВКА С КРЕПЛЕНИЕМ НА СТЕНЕ CAUTION: NEVER EXCEED THE MAXIMUM LOAD CAPACITY OF 125 LBS (56.7 KG) ATTENTION : NE JAMAIS DÉPASSER LA CAPACITÉ DE CHARGE MAXIMALE DE 56,7 KG (125 LBS) UWAGA: NIGDY NIE PRZEKRACZAJ MAKSYMALNEGO DOPUSZCZALNEGO OBCIĄŻENIA 56.7 KG ПРЕДУПРЕЖДЕНИЕ: НИ...
Page 18
Fig. 3-2 • Height to bottom of TV • Hauteur jusqu'au bas du téléviseur • Wysokość do spodu telewizora • Высота до нижней грани телевизора 3-2. MEASURE the distance from the mounting holes on the back of your television to the top and bottom edges of the television to determine the true center of the television once it will be mounted.
Page 19
Fig. 3-3 2.5" (64 mm) 5/32" (4 mm) INSTALLING THE WALL MOUNT IN WOOD: 3-4. DRILL four holes 2.5" (64 mm) deep using a 5/32" (or 4 mm) size drill bit in the “A”, “B”, “C”, and “D” locations noted on the Installation Template.
Page 20
Fig. 3-5 3" (76 mm) MOUNTING TO SOLID CONCRETE OR CINDER BLOCK: 3-4. Carefully DRILL four holes using a 5/16" (or 8mm) masonry drill bit in the “A”, “B”, “C”, and “D” locations noted on the Installation Template. NOTE: EACH HOLE SHOULD BE AT LEAST 3" (76 MM) DEEP. [FIGURE 3-5] IMPORTANT: DO NOT DRILL INTO MORTAR JOINTS! DRILL HOLES AT LEAST 1"...
Page 21
3-5. REMOVE the Installation Template. Fig. 3-7 3-6. If mounting into concrete, INSERT four TOGGLER brand Wall Anchors (YF25) into ® the drilled holes. [FIGURE 3-9] YF21 3-7. PLACE the Wall Plate (YF21) over the holes and SCREW in the Lag Bolts (YF26) about half way.
Page 22
Fig. 3-10 YF22 YF21 Fig. 3-10a 3-8. With the help of an assistant, carefully LIFT and ATTACH the TV with the Monitor Arms (YF22) to the Wall Plate (YF21). MAKE SURE both Monitor Arms are correctly attached, then SECURE the Monitor Arms using two 25 mm Screws (YF6) as shown in Fig.