Publicité
Les langues disponibles
Les langues disponibles
ATTACH THE REAR WHEEL
❶ Loosen the axle nuts on the rear wheel. If there is a washer
inside of the axle nut, it belongs outside of the fork
dropouts.
❷
Important! Be sure the wheel is as centred as possible
between the fork legs.
❸ Place the washer on the axle and slide it up against the fork
drop out. Figure 2.6
Important note! The style of washer may vary depending
hook washer.
❹
wheel remained centered between the fork legs.
If it is not centred, loosen the axle nut on the side
❺
with the smaller gap between the tyre and fork leg. Use
your hand to push the wheel to a centred position. Hold
the wheel with one hand and tighten the axle nut and
check again. Repeat if needed, to ensure the wheel is
centred and securely tightened.
Figure 2.6
2.7 if your model has a
Water proof
plastic cap
4
Axle nut
Was
her
(for EXPO mod
els)
2
Axl
e
Fork dropout
Dropout hole
13
3
(for TRACE models)
3
3
Hook washer
inserted into
dropout hole
Figure 2.7
4
Figure 2.6
Publicité
