Toolland FT 15 Mode D'emploi page 16

FT 15

Connect the hose to the appliance.
Securely tighten all gas connections.

Connect the power cord to the power
supply.
4.2 Start

Connect the power cord to the power
supply socket.

Let the fan blower run during 30 seconds.
This for checking if the fan works and the
appliance purge fuel.

Open gas supply valve on the gas
cylinder slowly. Be sure there is no gas
leak.

Push and hold the automatic control valve
button. Push piezo ignitor button
repeatedly until the burner lights.

After the burner lights, keep the gas
valve button depressed for 30 seconds
then release and the heater will continue
to operate.
4.3 Stop

Securely close valve on the propane
cylinder.

Continue to operate heater until all fuel in
the hose has burned.

Let the fan blower run at least 2 minutes
to cool the appliance.

Unplug the supply cord
4.4 Restart after safety shutdown

Securely close the valve at propane
cylinder. Unplug power cord.

Wait for 5 minutes.

Restart following the start procedure
(5.1)
5. MAINTENANCE

Always turn off the appliance before
cleaning it and wait till it is cooled
completely.

To clean the outside of the heater, use a
soft cloth soaked with water and a liquid
detergent. Do not use scouring pads or
abrasive products. Do not use water or
abrasive products.

Regularly inspect the atmosphere
analyzer and the aeration holes.

Regularly check the condition of the
connections. Check the condition of the
www.toolland.eu
hose and the pressure regulator every
time the gas cylinder is changed.

Take care not to hit or damage the
surface of the burner, the fittings and gas
tubes, the tap and all the other
components of the gas circuit.

We recommend that you have the heater
inspected once a year by a qualified
professional.

If you decide not to use the heater for an
extended period, you must follow the
instructions bellow:
- Close the tap on the cylinder and
disconnect the pressure regulator
from the cylinder.
- Store the cylinder in a well-ventilated
room, far from inflammable or
explosive materials and preferably
outside your home. Never store the
cylinder in a basement or attic.
- The heater must be stored in a dry
place and protected from dust. It is
recommended to store the heater in
its original packaging.
6. ENVIRONNEMENT
Should your appliance need replacement
after extended use, do not put it in the
domestic waste but dispose of it in an
environmentally safe way.
7. WARRANTY
Refer to the enclosed warranty conditions for
the terms and conditions warranty.
8. TECHNICAL SPECIFICATIONS
Voltage
Frequency
Puissance
Gas category
Gas type
Pressure
IP classifications
Consumption
Garantie
230V
50Hz
15kW
I3P
Propane
380mbar
IP.44
1,07kg/h
12