Publicité
Les langues disponibles
Les langues disponibles
Remote control
Please use Lithium battery CR2025 3V.
NOTE: the remote control buttons perform the same functions as those on the control
panel on the unit.
OVERHEAT PROTECTION
This heater is protected with an overheat protection that switches off the appliance
automatically in case of overheat, e.g. due to the total or partial obstruction of the grids.
In this case, unplug the appliance, wait about 30 minutes for it to cool and remove the
object which is obstructing the grids. Then switch it back on as described above. The
appliance should operate normally. Should the problem persist, please contact the
nearest customer service.
TIP-OVER PROTECTION
This heater is protected with a safety switch that turns off the appliance automatically
when the heater falls over, or is at an excessive angle from the horizontal. This helps
prevent accidents, and the heater will back to the standby mode when it is put back
upright, press the buttons on control panel or remote control to reset the heater.
MAINTENANCE
1. When your heater needs cleaning, wipe exterior surfaces of the heater with a
moistened cloth. Not rinse with water directly. Be sure to unplug before cleaning.
2. Pull out filters and clean them , when it's very dirty.
3. To prolong the heater life, not disassemble it personally when malfunction occurs.
Send your heater to relative identification after-sold service center or provider for the
convenience inspecting.
CORRECT DISPOSAL OF THIS PRODUCT
When the time comes to eliminate this product, please consider the environmental
impact and take it to recognized recycling facility instead of disposing it with
general household waste. Take the equipment to a waste disposal site. Plastic and
metal parts that are used in the construction of this appliance can be separated into
pure grade which allow recycling. Ask to your service center for details. Everyone of
us can participate on the environmental protection.
4
Publicité
