Publicité
Auto leveling
1. In "Settings" → "Leveling m ode"
2. 2mm feeler gauge between the nozzle and the hot bed → If the gap is to o thin or too large, click "Z+" or "Z-" on
the interface to adjust the gap to slightly more than 0.2 mm(the distance between the nozzle and the hot bed
should be about 0.2mm). At 0.2 mm the feeler can easily pass through the gap between the nozzle and the
printing platform.
Restore hot end to original
home position
*When using the auto level feature , we suggest that adding a raft from
the build plate adhesion section in software settings
Auto-level the printing surface
16 point precise bed height
measurement
Printer will automatically
Printer will automatically
compensate for variable
bed height
29
Publicité
