Publicité
Frame Assembly Pt. 2
Ready:
Top Frame
8pcs
M5X25
Step 1.
Make sure the front of the bottom frame is facing you .
Step 2.
1) Place the Top frame on top of all four aluminum frames.
2) Line up the pre-drilled screw holes on tops of aluminum frame with the holes on top of Top frame and tighten
in place with an M5x25 screw and washer at each corner.
3) After 4 screws on top are tightened, use 4 M5x25 screws and washers to fasten corner brackets in each corner of
Top frames, into corresponding holes on outside edge of aluminum frame
22
Front
Note:
1.
Tighten the four screws on the
top, then tight the side screws.
2.Facing your top-side Y-axis
passive block, you can adjust it
to
adjust
the
timing
belt
tightness
Publicité
