Burley Honey Bee Mode D'emploi page 10

Installing the Tow Bar
A B
1
While depressing the button, slide
the tow bar into the tow bar receivers
until hole A with hole B. the red
safety strap bracket should be flush
with the front of the reciever.
Removing the Tow Bar
1
remove the retaining pin,
and unclip the safety strap
2
While depressing button,
remove the tow bar
10
ASSEMBLY & uSE
2
Insert the retaining pin from the
top through the aligned holes.
Securing the Cover
1
Attach the velcro at the rear and slip the cover d-rings
over the hooks at the front corners of the trailer
ENG DEU
3
Ensure that the retaining pin is
locked properly as shown above
FRA ESP
4
clip the receiver safety strap to the
d-ring on the trailer frame.
BURLEY.COM