Black & Decker PRO Serie Mode D'emploi page 8

ENGLISH
Purpose of design
This angle grinder is designed especially for grinding.
Do not use sandpaper discs and grinding wheels other than
those with depressed center.
Do not use the tool in wet conditions or environments in the
presence of flammable liquids or gases.
This heavy-duty angle grinder is a professional power tool.
Do not allow children to come in contact with this tool.
Inexperienced operators are required to use this tool under
supervision.
Electrical Equipment Safety
Only one voltage is applicable to this tool. Be sure to check
that the power suuply corresponds to the voltage on the
rating plate.
Your Black & Decker tool is equipped with double
insulation, hence, it does not require to be earthed.
When the power cord is damaged, have it sent to a Black &
Decker service center for replacement to specially prepared
cables.
Using Extension Cords
If an extension cord is required, please select a 3-phase
extension cord that has been inspected and matches the
input power (see Technical Data) of this tool. The minimum
conductor size is 1.5mm2, maximum length is 30 meters.
When using a cable reel, be sure to pull out all the cables.
Assembly and Adjustment
Warning! To minimize the danger of serious
personal injury, please switch off the tool power
and disconnect all plugs before adjusting or
removing/installing any accessory. Before reassembling the
tool, press and release the trigger switch to make sure the
tool is already switched off.
Attaching and Removing the Wheel Guard
(Fig. 2)
Warning! To minimize the danger of serious
personal injury, please switch off the tool power
8
All manuals and user guides at all-guides.com
and disconnect all plugs before adjusting or
removing/installing any accessory. Before reassembling the
tool, press and release the trigger switch to make sure the
tool is already switched off.
Attaching the guard
1. Place the angle grinder on a work bench, groove facing
2. Bring the flange of the guard (c) collar over the groove (i)
3. Turn the guard (c) clockwise by 180 degrees.
4. Make sure that the screws (k) are tightened.
Removing the guard
1. Loosen the screws (k) on the guard collar.
2. Pull up the guard (c).
Note: Refer to the grinding accessories chart at the end of
this section for accessories that can be used together with
this angle grinder.
Attaching and Removing Grinding Wheels (Fig. 3, 4)
1. Place the tool on a work bench, groove facing up.
2. Attach the inner flange (d) correctly on the output shaft
3. Place the grinding wheel (f) on the inner flange (d).
4. Tighten the outer flange (h) until the output shaft (e) (Fig.
5. Press the spindle lock (b) and prevent the spindle (e)
6. Use the pin spanner to tighten the outer flange (h).
up.
of the gear housing.
Warning! Do not operate the tool when the
safety guard is not in place.
Warning! Do not use damaged grinding wheels.
(e) (Fig. 3).
When attaching a grinding wheel with a raised center,
make sure that the raised center (g) faces the inner
flange (d).
4). When attaching the grinding wheel, the ring on top of
the outer flange (h) must face the wheel.
from rotating until it locks in place.