Publicité
Les langues disponibles
Les langues disponibles
EN
tastes, and dispensing problems. Periodically monitor the temperature inside
of your kegerator and adjust as necessary and keep the keg cooler door closed
as much as possible to avoid temperature fluctuations.
SERVING RECOMMENDATIONS
If the beer comes out foamy on the first pour, this means too much CO2 built
up before the keg was tapped. Double check to pressure gauge on the C02
regulator to make sure that the PSI level is between 10-12. To release any
excess C02, pull the pressure release valve on the C02 regulator AND the
coupler. This should result in less foamy beer on future pours.
www.newair.com
14
Publicité
