Dörr Snapshot Mini 5.0MP Instructions De Fonctionnement page 5

Snapshot Limited 5.0MP (Art. Nr. 204471) /
All manuals and user guides at all-guides.com
Limited Black 5.0MP (Art. Nr. 204472)
User Manual
GB
System Settings (SYS)
Date & Time: Date to be set as dd.mm.yyyy, Time to be set in 24 h
Time Stamp: Choose if time & date are shown on pictures or not
Language: Choose either German or English language
Sound / Beep: Choose "beep" sound on keyboard input or "silent" mode
Overwrite function: Camera may overwrite old pictures with new ones when SD card is full or alternatively abandon function
Format: This function deletes all data on the SD card
Default settings: This sets all parameters to "factory defaults" except date & time
When settings are completed, press „MENU" to return to starting menu.
File name: Pictures and videos will be named continuously, starting with IMG0001.jpg (picture) or IMAG0001.avi (video)
Test shot: In setup mode press then "ok" to manually take a test shot
Installation of the Camera
Fix camera to a tree, pole or any suitable object. Best range is 3-10 meters from camera to object. For security reasons you may obtain cable lock optionally.
Directing the Camera
1) Hang up camera in about 0,75 - 1 m height, slightly tilting ahead
2) Switch camera to "setup" and close housing.
3) Move in front of camera. When red light is flashing you see the area which is covered by the PIR sensor
4) It is recommended to test the position and take several test photos, to see the area covered by the camera
5) Switch the camera off now
Start surveillance
Switch camera to "ON" , after 15-30 seconds camera is ready
Camera Check Up
Options to check if the camera has taken pictures:
1) Open camera housing and enter Setup mode
2) The lower line of starting menu shows the number of pictures taken and the remaining full space
3) Alternatively switch camera off and exchange the memory card by a fresh one. So you can view images on your computer or TV.
It is recommended to check the battery status as well. When capacity goes down, it will be more difficult to achieve correctly illuminated night shots.
In case of doubt, replace batteries by new ones.
Tips & Tricks
1. Memory Card
We recommend using the Dörr 4GB SDHC card 991050 memory card, which allows to store approx. 4000 pictures. Camera support cards up to 16GB.
2. Lens rattle
A filter covers the lens, it allows colored pictures at daylight and black & white shots at night. When camera is turned off the filter is not fixed which can cause the rattle.
Never mind your camera is not defective.
3. Weather resistance
Although the camera is weather resistant, we recommend to mount the camera in a protected area, where it is not exposed to direct rain or permanent sun.
Dust- and Waterproof (IP54).
4. Motion Detector (PIR Sensor)
The sensor reacts under specific condition and within a certain range. Generally the detection range is slightly smaller then the camera´s picture angle. The detection of
objects depends on temperature and other circumstances like vegetation and reflecting areas. Ideal conditions, perfect adjustment and high sensibility allow the camera to
reach 20m triggering. An average of 10m should be considered normal. Several testings are necessary to get the best position for the camera.
5. Light conditions
Consider that back light is not good to take proper pictures.
Carefully choose the position of camera, so it is not directly facing sun or complete shadow.
9. Subject to change. Latest manual download here:
http://download.doerrfoto.info/manuals/Snapshot%20manuals/
The CE marking complies with the European directives. You can download the relative EU declaration of conformity with following link:
http://www.doerrfoto.de/info/EG-Konformitätserklärungen/
DÖRR GmbH • Postfach 128
89202 Neu-Ulm/Germany
Fon +49 731 97037-0 • Fax +49 731 97037-37
info@doerrfoto.de • www.doerrfoto.de
www.doerrfoto.de
06 DÖRR GmbH • Postfach 1280 • 89202 Neu-Ulm/Germany Fon +49 731 97037-0 • Fax +49 731 97037-37 • info@doerrfoto.de