LUCCI Air NORDIC Guide D'installation page 8

Nordic Installation Instructions
INSTALL THE CANOPY
Loosen the 2 screws from the bottom of the mounting bracket.
•
Slide the canopy up to the mounting bracket and place the key hole on the canopy over the screw on the
•
mounting bracket. Turn the canopy until it locks in place at the narrow section of the key holes and secure it
by tightening the 2 set screws. Avoid damaging the electrical wiring prepared previously.
BLADE INSTALLATION
Loosen the 3 blade holders from motor.
•
Secure the blade to the blade holder by tightening the 2 blade screws with washer. Fig.7
•
Repeat to install the other blades to the blade holders.
•
Install the blade assemblies to the motor by tightening the 2 motor screws. Fig.8
•
Finally, install the bottom cover to the lamp bracket by rotating it clockwise. Fig.9
•
Fig. 8
7 | P a g e
FINISHING THE INSTALLATION
Fig. 6
Fig. 7
Fig. 9