PANCONTROL PAN 186 Manuel D'instructions page 39

All manuals and user guides at all-guides.com
1. Set the rotary switch to the position
2. Attach the pin-plug of the black test lead to the COM-jack and the
pin-plug of the red test lead to the V-, Ω-, Hz-jack.
3. Connect the black test prod to the negative pole and the red test prod
to the positive pole of the circuit to be tested.
4. Once the reading stabilizes, read the value. If the polarity is twisted a
"Minus sign" is displayed. Use the HOLD function if the reading is difficult to
read.
Diode testing
1. Set the rotary switch to the position
2. Touch the diode to be tested with the probes. The forward voltage shows
400 to 700mV. The counter voltage shows „OL". Defective devices show a
value about 0 mV or „OL" in both polarities.
Frequency measurement and Duty cycle
1. Set the rotary switch to the position Hz %
2. Select with the "SEL" button Hz or %
3. Attach the pin-plug of the black test lead to the COM-jack and the pin-plug
of the red test lead to the V-, Ω-, Hz-jack.
4. Once the reading stabilizes, read the value. If the polarity is twisted a
"Minus sign" is displayed. Use the HOLD function if the reading is difficult
to read.
Capacity measurement
To avoid electric shock, switch off the current of the device under test and
unload all capacitors before performing these measurements.
1. Set the rotary switch to the position
2. Attach the pin-plug of the black test lead to the COM-jack and the pin-plug
of the red test lead to the V-, Ω-, Hz-jack.
EN 13