Sony SDM-X75 Serie Mode D'emploi page 31

5
Hook the Stand Base holes onto the prongs of stand
to attach. 1
Lift the handle of screw to screw the stand base
securely. 2
Be sure that the screw is secured and turn the screw
handle back.
6
Remove the stopper pin after raising the height
adjustable stand straight.
Note
Do not remove the stopper pin while the stand is laid. It may fall or injure
you by the stand neck coming off from the Stand Base impetuously.
x When using VESA Stand
You can attach a VESA stand in other brand by removing the
supplied stand attached to the display.
1 Stand Base
2 Screw
Stopper Pin
Screws
compatible with
VESA stand (4)
Setup 2: Connect the video signal
cables
• Turn off the display and computer before connecting.
Notes
• Do not touch the pins of the video signal cable connector as this
might bend the pins.
• Check the alignment of the connector to avoid bending the pins of
the video signal cable connector.
1 Slide down the connector cover.
2 Tilt the display up.
And then move the display's angle higher.
7
Connector cover
GB