Samsung DMR57 Serie Guide D'installation page 6

installing the dishwasher
Be sure that you or your installer follow these instructions closely so that the new
dishwasher works properly and that you're not at risk of injury when washing dishes.
STEP 1 CHECKING THE PARTS AND TOOLS
Before starting on the installation, prepare all the necessary tools and parts required to install the
dishwasher. This will save installation time and simplify the installation process.
Parts required
Provided with the dishwasher. Check when you unbox the dishwasher in Step 5.
2 Installation Brackets
Kick Plate
Not provided
Power cable
Hot water supply line
Hose clamp
For the hot water supply line – We strongly recommend using 3/8" minimum O.D. copper
tubing with a compression fi tting or a fl exible stainless steel braided hot water supply line.
[Warning: Do not use plastic tubing. Plastic tubing can deteriorate over time and cause a
leak inside the tube fi tting.]
You also need a 90° elbow with 3/8" N.P.T. external pipe threads on one end and a fi tting
sized to fi t your hot water supply line (copper tubing/compression fi tting or braided hose) on
the other.
For the power cable, we recommend a jacketed 12-2 cable with ground. Note that some
local codes may require the cable to have a BX style metal jacket.
6_ installing the dishwasher
DMR77LH_DMR57LH-00027A_EN_v1.indd Sec3:6 DMR77LH_DMR57LH-00027A_EN_v1.indd Sec3:6
2 Flat Head Screws
(For the installation
(for the side walls)
bracket)
Twist on wire
connector
90° Elbow(3/8")
Air gap Rubber connector
2 Screws 2 Screws
(for the kick plate)
Electrical tape &
Strain relief
Standard duct tape
Tefl on ® tape or sealing
Tube fi ttings
compound
2011-04-05 2011-04-05 2:17:04 2:17:04