Samsung DMR57 Serie Guide D'installation page 20

installing the dishwasher
STEP 11 WIRING CONNECTIONS
1. Before connecting the power cable to the dishwasher, make sure the circuit breaker is off.
2. In the junction box located at the front bottom right of the dishwasher, fi nd the three power
wires from the dishwasher including the grounding line.
3. Pass the power cable through the strain relief, and then into the junction box (Figure 13).
4. Connect the black wire of the dishwasher to the black wire of the power cable by insertng
both into a wire nut. and then rotating the wire connector as shown in Figure 14.
Connect the white wire to the white wire and the green to the green in the same manner.
5. Recheck each wire to ensure it is connected correctly and securely.
Each colored wire should be connected to the corresponding wire of the same color.
White should be connected to white, black to black, and green to green.
6. Replace the junction box cover on the dishwasher.
<Figure 13>
<Figure 14>
20_ installing the dishwasher
DMR77LH_DMR57LH-00027A_EN_v1.indd Sec3:20 DMR77LH_DMR57LH-00027A_EN_v1.indd Sec3:20
Power cable
Junction box
Strain relief
Black to black
White to white
Green to green
(Ground to ground)
2011-04-05 2011-04-05 2:17:08 2:17:08