Publicité
Les langues disponibles
Les langues disponibles
6.1 Turning on the backlight
All manuals and user guides at all-guides.com
Press the "SET" and the "MODE" button at the same time to turn the
backlight on or off. Either EL ON (backlight switched on) or EL OFF
(backlight switched off) is shown in the display. If the backlight is swit-
ched on, it glows each time for 3 seconds unless a button is pressed.
7 Buttons and functions
Mode button:
You can change between the different functions using the "MODE"
button.
Set button:
You can adjust the values in the settings or, for example, start the built-
in stopwatch, using the "SET" button.
Resetting:
Press and hold the "SET" button for 5 about seconds. "RESET" appears
on the display. This will flash twice, and then the corresponding value
is reset.
This function can be used only in the "Ride time (RTM)", "Distance
covered (DST)", "Maximum speed (MXS)" and "Average speed (AVS)"
modes.
Sleep mode
The bicycle computer starts the sleep mode (auto ON/OFF) if it does
not receive any signal after about 4 minutes. The current speed is not
displayed during the sleep mode.
To reactivate the device, it has to receive a signal at the sensor. Or
press any button to do this.
8 Replacing the battery
Replace the batteries when the battery icon appears on the display or
the display becomes difficult to read. Before replacing the batteries,
please ensure (if desired) that you record the total distance covered
(ODO) because it is reset when the battery is replaced.
26
English
Publicité
