Danfoss 088U0212 Instruction page 6

All manuals and user guides at all-guides.com
Instruction CF-RD Room Thermostat with Display
Activate Install mode on Master Controller
- fig. 1
• Use the menu selection button
Install mode. Install LED
• Activate Install mode by pressing OK
LED goes ON
Activate Install mode on Room Thermostat
• Press the push button
during communication
Select output on Master Controller
• All available output LEDs on Master Controller
light up, and the first of them flashes
• Press output selection button
output (flashes) and accept with OK
• All output LEDs
stays ON shortly
Room Thermostat installation status
• Satisfactory - LED
• Not satisfactory - LED
Note: A Room Thermostat can be assigned to several
outputs if needed by repeating the installation process.
VI.UH.Q4.1C
flashes
. LED
go OFF. Selected output
goes OFF
flashes 5 times
Produced by Danfoss Floor Heating Hydronics 03.2007
to select the
. Install
and flicker
, select desired
GB
5