Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Mounting the Camera on a Wall Safely:
Before drilling the holes, it is important to check the reception and camera positioning
in the intended location on the wall. Ensure you are hanging the camera no less than 3
feet away from baby's crib.
Note: Baby monitors and cameras with power cords should never be hung on or
near the crib as it is a strangulation hazard. Power cords should be kept no less
than 3 feet away from the crib and the baby's reach at all times.
1.
Pre-drill two holes in the wall using a 3/16", 4.8mm drill bit.
2.
Insert wall anchors (not included) into each hole and tap gently with a hammer
until the anchor is flush with the wall.
3.
Insert a screw (not included) into each wall anchor and tighten until the screws
only stick out about a 1/2 inch.
4.
Plug the power cord into the power input of the camera.
5.
Locate the wall mounting holes on the bottom of
the camera base.
6.
Slide the holes over the screws sticking out of
the wall.
7.
Confirm that the camera is secure, if it is loose
you may have to tighten the screws more.
8.
Use wall clips (not included) to secure the power
cord away from the crib or the baby's reach.
9.
Connect the other end of the adapter into an
available wall outlet.
mylevana.com
All manuals and user guides at all-guides.com
14
Publicité
