Honeywell HZ-940 Serie Mode D'emploi page 3

All manuals and user guides at all-guides.com
HZ-940_OM.qxd 7/17/06
ASSEMBLY INSTRUCTIONS (CONT'D.)
• Step 3: Place hand approximately 1/3 of the way
down on the heating bulb and push bottom end of
the heating bulb into the bottom socket connector,
firmly pushing down into the metal spring (Fig 6).
While still pushed down at the bottom, withdraw the
failed bulb from the heater (Fig. 7).
CAUTION: DO NOT GRAB HEATING BULB BY THE
MIDDLE TO PLACE IN OR PULL OUT OF SOCKET
CONNECTORS. THIS COULD CAUSE THE BULB TO
BREAK.
• Step 4: Place hand approximately 1/3 of the way down on the heating bulb and
place bottom end of the heating bulb into the bottom socket connector, firmly
pushing down into the metal spring (Fig 6). While still pushed down at the
bottom, place the other end of the heating bulb into the metal spring of the top
socket connector and release (Fig. 7).
CAUTION: DO NOT GRAB HEATING BULB BY THE MIDDLE TO PLACE IN OR
PULL OUT OF SOCKET CONNECTORS. THIS COULD CAUSE THE BULB TO
BREAK.
• Step 5: Replace the grille door and insert the screws using the phillips screwdriver (Fig. 8). Make sure
the screws are securely tightened; however, do not overtighten causing stripping of the screws.
CAUTION: WHEN REPLACING A BURNT OUT HEATING BULB WITH A NEW ONE, PLEASE MAKE SURE
THE BURNT OUT ELEMENT HAS COMPLETELY COOLED BEFORE HANDLING.
Dispose of failed bulb properly.
HZ-940 SERIES OPERATION
• Place the heater on a firm, level, open
surface free from obstructions at least 3
feet (0.9 m) away from any wall, furniture
or combustible material.
• With Power Knob in the OFF ( ) position,
plug the heater into a grounded outlet
(Fig. 9).
• Turn the Power Knob to HIGH (
or Low ( ) (450W) to start the heater.
NOTE: ENERGY EFFICIENT SETTING = LOW
OR ( ) This portable space heater includes an
energy efficient setting which is the low setting. Because a lower heat setting does not require as much
electricity to operate, it is more energy efficient and may be a better option if you are concerned about
high power consumption.
• Turn the Power Knob to OFF ( ) and unplug the heater when not in use.
NOTE: This product is equipped with a SafeGuard
SafeGuard ™ Alert Badge located on the top of the grille changes from black to red the grille is hot to
the touch.
Do not touch the grille until the unit has been turned off and the SafeGuard
turned back to black.
4:28 PM Page 3
Fig. 6
Bottom
Socket
Connector
Fig. 9
Power Knob
) (900W)
™ Alert Heat Indicator Badge (Fig. 10). When the
Fig. 7
Heating
Bulb
Top Socket
Connector
Fig. 8
Fig. 10
Heat
Indicator
Badge
Reset Button
™ Alert Badge has