Yardworks 060-3711-6 Guide D'utilisation page 31

31
model number 060-3711-6 | contact us: 1.866.523.5218
PROBLEM
The handle is
not in position.
The
snowthrower
doesn't start.
The motor is on,
but the impeller
does not turn.
The
snowthrower
leaves a thin
layer of snow
behind.
All manuals and user guides at all-guides.com
POSSIBLE CAUSE
The bolts are not properly
seated.
The battery is not charged.
The switch is defective.
Battery is too cold.
The battery is not attached
to the motor.
Battery may require service
or replacement.
The belt is damaged.
The scraper is worn.
SOLUTION
Make sure the bolts are
correctly installed through the
handle bars. Check to see if the
hand knobs are tight. Refer to
Assembling the Handle section
in this manual.
Charge the battery by following
the procedures in the battery
and charger manual.
Have the switch replaced by an
authorized service centre.
Remove battery from
snowthrower. Place battery on
charger and allow to charge
for 10 minutes. Remove
from charger and install in
snowthrower for use.
Check the connection between
the motor connector and the
battery.
Call toll free helpline at
1.866.523.5218 or replace
battery.
Replace the belt (see the section
entitled Replacing the Drive
Belt).
Inspect the scraper for wear or
damage. Replace the scraper
(see the section entitled
Replacing the Scraper).