Warnings And Safety Precautions - Denver Instrument TP Série Mode D'emploi

Warnings and Safety Precautions

Safety
§ To prevent damage to the equip-
ment, please read these operating
instructions carefully before using
your balance.
Do not use this balance in a haz-
!
ardous area/location.
! Make absolutely sure to unplug
the balance from AC power before
you connect or disconnect a
peripheral device.
Exposure to excessive electromag-
!
netic disturbance can cause the
readout value to change. Once the
disturbance has ceased, the instru-
ment can be used again in accor-
dance with its intended use.
4
Setting up the Balance
Warning when using pre-wired
!
RS-232 connecting cables: The pin
assignments in RS-232 cables pur-
chased from other manufacturers
may be incompatible with DENVER
balances. Be sure to check the pin
assignment against the chart on
page 21 before connecting the
cable, and disconnect any lines
that do not match.
– Connect only DENVER accessories
and options, as these are optimally
designed for use with your DENVER
balance. Do not try to solve any
problems on your own. The opera-
tor shall be responsible for any
modifications to DENVER equip-
ment and for any connections of
cables or equipment not supplied
by DENVER and must check and, if
necessary, correct these modifica-
tions and connections. On request,
DENVER will provide information
on the minimum operating specifi-
cations (in accordance with the
standards for defined immunity to
interference).
– Do not open the balance housing.
If the seal is broken, this will result
in forfeiture of all claims under the
manufacturer's warranty.