Publicité
OPERATING INSTRUCTIONS
FILLING THE WATER TANK
Fill the water tank with tap water or distilled water. Do not use chemi-
cally descaled water or any other liquids.
1. Unplug and allow the iron to cool before filling.
2. Move the Variable Steam to no steam setting.
3. Slide the Water Fill Cover away from
the iron handle to open.
4. Fill water through the Water Tank
Opening (see FIGURE 8).
5. Fill to the MAX level as marked on the
Water Tank (see FIGURE 1).
6. Slide the Water Fill Cover toward the
iron handle.
USING AS A STEAM IRON
See Before Using For The First Time.
1. Position the Temperature Control to the OFF position (see Figure 7).
2. Unplug the iron from the outlet.
3. Fill the Water Tank with water; see FILLING THE WATER TANK.
4. Stand the iron on its heel in an upright position on a heat resistant
surface. Plug into a 120 V ~ 60 Hz outlet.
5. Turn the Temperature Control to the wool setting or higher. Do not
use the steam function with the Temperature Control selected below
the wool setting.
6. Tilt the iron to the horizontal position (see Figure 5) to turn the iron
on. It may then be returned to the vertical position (see Figure 6) to
preheat the iron.
7. Allow approximately 45 seconds for the iron to reach the desired
temperature. The red Power On/Heating Light will turn off. The light
will continue to turn off and on during use to maintain the proper
temperature.
8. Move the Variable Steam for more steam.
9. When finished, turn the Temperature Control to the OFF position,
turn Variable Steam to the no steam position and unplug iron. Allow
iron to cool before cleaning the exterior of the iron for storing.
CAUTION: AVOID COMING IN CONTACT WITH ESCAPING STEAM.
(Cont.)
9
FIGURE 8
Publicité
