Publicité
OPERATING INSTRUCTIONS
USING AS A DRY IRON
The iron can be used on the dry setting with or without water in the
Water Tank. However, it is best to avoid having the Water Tank too full
of water while dry ironing.
1. Position the Temperature Control to the OFF position
(see Figure 7).
2. Move the Variable Steam to the no steam position (see Figure 2).
3. Stand the iron, on its heel, in an upright position on a heat resistant
surface. Plug into a 120 V ~ 60 Hz outlet.
4. Move the Temperature Control to the desired setting.
5. Tilt the iron to the horizontal position (see Figure 5) to turn the iron
on. It may then be returned to the vertical position (see Figure 6) to
preheat the iron.
6. When the red Power On/Heating Light goes off, the iron has
reached the desired temperature. The light will continue to turn off
and on during use to maintain the proper temperature.
7. When finished using, move the Temperature Control to the OFF
position and unplug. Allow the iron to cool before cleaning the
exterior or storing.
CAUTION: IF THE IRON IS HOT, DO NOT FILL WITH WATER.
OFF Position
FIGURE 7
8
Publicité
