Publicité
Les langues disponibles
Les langues disponibles
1.
Grounded tools require a three wire extension cord.
2.
As the distance from the supply outlet increases, you must use a heavier gauge
extension cord. Using extension cords with inadequately sized wire causes a seri-
ous drop in voltage, resulting in loss of power and possible tool damage.
(See table A.)
3.
The smaller the gauge number of the wire, the greater the capacity of the cord. For
example, a 14 gauge cord can carry a higher current than a 16 gauge cord.
WARnIng! do not use 16 or 18 AWg extension cords on this product.
4.
When using more than one extension cord to make up the total length, make sure
each cord contains at least the minimum wire size required. (See table A.)
5.
If you are using one extension cord for more than one tool, add the nameplate am-
peres and use the sum to determine the required minimum cord size.
(See table A.)
6.
If you are using an extension cord outdoors, make sure it is marked with the suffix
"W-A" ("W" in Canada) to indicate it is acceptable for outdoor use.
.
Make sure your extension cord is properly wired and in good electrical condition.
Always replace a damaged extension cord or have it repaired by a qualified electri-
cian before using it. Protect your extension cords from sharp objects, excessive
heat, and damp or wet areas.
REcOMMEndEd MInIMUM WIRE gAUgE fOR POWER cORdS* (120 V)
NAMEPLATE AMPERES
(At Full Load)
12.1 - 16.0
16.1 - 20.0
* Based on limiting the line voltage drop to five volts at 150% of the rated amperes.
Canadian Standards Association
Intertek, Electrical Testing
Laboratories Semko
V~
Volts Alternating Current
for technical questions, please call 1-800-444-3353;
SKU 95338
troubleshooting section at end of manual.
All manuals and user guides at all-guides.com
EXtEnSIOn cORdS
Table A
POWER CORD LENGTH
25
50
Feet
Feet
14
12
12
10
Symbology
Table B
n 0 xxxx/min.
OVER 50 fEEt
Extension cords must
nOt be used.
A
Amperes
No Load Revolutions per Minute
(RPM)
PAGE 9
Publicité
