Pacific hydrostar 95338 Manuel D'installation Et Operation page 10

nOtE: For additional information regarding the parts discussed in the following pages,
refer to the Assembly diagrams near the end of this manual.
Check the Inlet Strainer for any blockage, including packaging debris. The Pres-
1.
sure Washer may be shipped with a plastic plug in the Inlet.
dEtERgEnt
PORt
(Hidden behind
Handle)
dEtERgEnt
tUbE (32A)
Position the rear of the Handle (28a) above the rear of the Pressure Washer body.
2.
Insert the Valve located at the bottom of the Handle into the Suction Tube located
at the top of the Pressure Washer body. Make sure that the Suction tube does not
bend or get pinched during assembly. Lower the Handle fully onto the Pressure
Washer Body. Then secure the Handle to the Pressure Washer body, using the
Screws (25a) provided. (See Figure D.)
for technical questions, please call 1-800-444-3353;
SKU 95338
troubleshooting section at end of manual.
All manuals and user guides at all-guides.com
ASSEMbly
REAR
VIEW
HAndlE
(28A)
fIgURE d
ScREW
(25A)
ScREW
(25A)
PAGE 10