Publicité
Les langues disponibles
Les langues disponibles
be cERtAIn to shut off the Pressure Washer, release all pressure in a safe manner, and
disconnect it from power and water before adjusting, cleaning, or repairing the unit.
SWItcH IS lIt
the thermal safety Switch may be
tripped. Switch the unit off and allow the
unit to rest for 20-30 minutes and retry.
UnIt OPERAtES
nORMAlly AftER
REStIng
the following points should
be applied to help reduce the
frequency of rest periods:
1.
Use proper operating techniques. Re-
view the Operating tips section, start-
ing on page 16.
2.
Verify that this unit is being supplied
with the correct voltage, see page 14,
#2.
connect the plug to the outlet
nearest the circuit breaker panel and
remove any other loads that may be
on the circuit.
Reduce the length of or eliminate any
3.
extension cord used, see page 9.
Water leaking from within the housing
Seals or gaskets may be worn or damaged.
If the steps above do not solve the problem or if the repairs involved are
SKU 95338
for technical questions, please call 1-800-444-3353.
All manuals and user guides at all-guides.com
tROUblESHOOtIng
IMPORtAnt!
Pressure Washer Stops Suddenly
check whether the power switch is on
and lit.
UnIt dOES nOt
REStARt
Contact qualified
technician.
dry self thoroughly
and check the circuit
breaker on your
household panel.
bREAkER
nOt tRIPPEd
contact
qualified
Leaking water creates a shock hazard;
PrOMPtly have the unit inspected and
repaired by a qualified technician.
too complex, contact a qualified technician.
SWItcH IS nOt lIt
check the indicator on the gfcI power
plug (explained under Controls and
Features, #2 on page 12).
IndIcAtOR
APPEARS
bREAkER tRIPPEd
check for electrical shorts.
If none are found, reset
breaker.
If breaker continues to trip,
try another circuit or contact
a certified electrician.
IndIcAtOR dOES
nOt APPEAR
Make sure unit is
totally dry, then
press reset button.
If gfcI continues
to trip, contact a
certified electrician.
PAGE 24
Publicité
